Got a Plumbing Emergency? Call us now: 0402 290 290

4 Foolproof Ways Extend Your Water Heater’s Serviceability

plumber parramatta 4 Foolproof Ways Extend Your Water Heater’s Serviceability

High-quality water heaters are worthwhile investments. After all, heating systems have high utility especially in homes that thrive in cold climate. Chilly showers early in the morning would definitely be cruel.
However, homeowners should not play complacency when it comes to the proper upkeep of their appliance. Even if they brought the latest and most durable unit available, the water heater will eventually degrade as it ages. Soon, the appliance will not be in its tip-top shape to perform its operations and you will have to repair or replace it.
This article highlights the four foolproof ways you can do to prolong the service lifespan of your water heating systems.

1. Flush out the water in the tank and remove the sediment build-up

Homeowners need not to worry much about sediment accumulation if their heaters are newly installed. But take note that once a heater had been working for a year, you may have to clear the sediment build-up that has been amassed in the tank.
Flushing out your storage tank at least once a year is a must so as to thwart off any damages in the integral components of your device. Moreover, the tank may serve as a breeding ground for bacteria if the sediments are not removed from time to time.
Most areas that have hard water supply typically have a fast rate when it comes to sediment accumulation. If you live in such location, installing a water softener to reduce the mineral concentration of your water supply is advisable.

2. Insulate your water heater properly

It is not only your pipes that need insulation; your water heater also needs it. By wrapping up your tank with an insulating blanket, you can reduce the heat being wasted during its heating mechanisms. Make sure you do not cover the temperature relief valve as well as the top part of your heater (for gas heaters) to avoid interfering with its operations. You can contact your trusted plumber to help you in insulating your device if you have no experience doing it.

3. Check if the anode rod needs replacement.

The internal parts of your water heater are always submerged in water so they are vulnerable to rust and corrosion. The best thing to deter the corrosive agents is to place an anode rod in your appliance that can absorb the rust instead. Of course, the anode rod will eventually deteriorate and you will have to replace it after some time.
For water heaters that have lasted for 2 years already, check on the anode rod since it is likely on the verge of its limit due to severe corrosion. Small spots of rust and sediment build-up are just normal but if the rod is obviously tarnished and there are already missing sections, replace it already.

4. The temperature relief valve should be properly functioning

The temperature relief valve regulates the heating temperature and pressure of your water heater and makes sure the device does not exceed its limit. If not for this valve, overheating may occur or the pressure surges up until the device blows up. By discharging water from the tank, the temperature relief valve prevents overheating and excessive pressure.