Got a Plumbing Emergency? Call us now: 0402 290 290

6 Hassle-free Techniques to Maintain Water Heaters

Plumberparramatta hands

Water heaters should never be neglected, as well as your other appliances at home, be it plumbing appliances or not, should always be given little but constant attention. This is to ensure that they do their job effectively and to free them from the troubles caused by the lack of maintenance. Most homeowners only pay attention to their water heaters when it is already experiencing troubles when you could have avoided them to happen. Even when they are doing their job well, quietly and effectively, routine maintenance should be always conducted to remove all the possibilities of future troubles. Here are six tips on how to avoid water heater problems from arising.

● Sediment flush

Once every week, it is advisable to flush your water tank especially when you do utilise hard water at home. This water often carries minerals and sediments with them such as chalk, calcium, silt and sand. Because of their weight being higher than that of the water molecule’s weight, they would then settle at the base of the tank acting as insulators hindering the water heating procedures. Flushing and getting rid of them will avoid exploding your water heater unit.
Here are the steps on how to drain the sediments contained by your water heater tank.

1. Turn off the water heater unit – this is to avoid accidents and electrocution especially when your water heater is electrically powered.

2. Place a garden hose in the drain valve – drain valves are commonly located at the bottom part of the tank. This is done to drain the water contained by the tank.

3. Close the cold water valve – this is located at the top of the appliance. This is to stop the continuous supply of cold water while draining the tank.

4. Break the vacuum – this is done by operating the pressure relief valve and getting rid of the vacuum.

5. Open the drain valve – this will then drain all the contents of the water heater tank, be it water or sediment.

● Set the temperature in a safe range

Your water heater’s thermostat doesn’t need to be set in a very high range. Too much temperature can cause the unit to explode. Set the thermostat in a safe range enough for a lovely bath to be made possible. Set your thermostat at 115 to 120 degrees Fahrenheit. This is to avoid explosion and save water heating bills.

● Water heater unit insulation

When your water heater at home is one of the latest models in the market, you may not need to insulate them, but when you are utilising the conventional unit, you would probably need to do so. The aim of doing this is to reduce the stress of the appliance as well as your water heating bills. You can do this by wrapping your unit with a water heater jacket or a pre-cut blanket available in most home improvements stores.

● Replace anode rod when necessary

The sacrificial anode rod can be either made up of brass or magnesium metals that hang within your water heater tank and soaked in its water content. As time passes by, electrochemical reaction would cause this rod to corrode. When not replace, the tank will end up corroding as well. That is why it would be best to replace them.

● Clean the heating element
Your water heater at home can be either gas-powered or electrically-powered but you should clean both heating systems.

1. Gas-powered water heater – the first thing to is to turn off the gas before removing the panel to avoid gas leakage. Then clean the panel by removing the dust accumulations with the help of a wire brush.

2. Electric water heater – just like the gas-powered water heater, power supply should always be turned off before making a single step in the cleaning process. You can start draining the tank and cleaning the mechanism with vinegar solution to remove any form of build-up, and then turn the water heater back on once you are done.

● Diagnose the unit and seed for an expert advice
Water heater should be diagnosed by a professional plumber annually to check its current condition. You should engage with them sometimes because they can detect troubles more than you could. They can also give you some tips to avoid problems from arising.