How to Properly Care for your Water Heater
Your water heater will degrade as it gets older which is why you should be able to do the necessary maintenance to prolong its expected lifespan. The new heating units that are made are more durable than its old counterparts, but you shouldn’t be too overconfident with its toughness and just leave it without any form of upkeep. Keep your heating system in the best state by learning how to properly care for your water heater.
Drain the water in the tank and take out the sediment build-up
If your water heater is still newly installed then you wouldn’t have to worry too much about the sediment accumulation, but once your it is already a year old since its first set up in your house then you clean out the tank. It’s highly recommendable to flush your storage tank at least once a year. It’s not a good idea to leave the tank with sediment build-up since this can become the breeding ground of bacteria and will also cause damage to the components of the heating system. Areas that have hard water can have sediment build-up at a fast rate. If you live in such locations then you need to install a water softener to lessen the mineral content of your water supply.
Replace the anode rod if necessary
The inner parts of the water heater are always drenched with water so it will be such a big problem if the parts become rusty. The solution for this was to install an anode rod to absorb all the rusts and corrosion. This anode rod won’t last for a decade which is why you need to check and replace it if necessary. If your newly installed water heater is already two years old then you need to start inspecting the anode rod for heavy corrosion. Don’t change if there are only small patches of rusts and sediment accumulation since this is perfectly normal, but if the rod is mostly corroded and missing sections due to rusts then you need to have it replaced as soon as you can.
Temperature relief valve should be always optimal
The temperature relief valve helps in controlling the temperature and pressure of the water heater from going over the limit. Without this valve, the water heater will overheat or experience high pressure until it explodes. The temperature relief valve automatically releases water from the tank in order to cancel overheating and high pressure.
Insulate your water heater
Insulating your water heater will make it more efficient and lower the wasted heat. The best and simplest way to insulate your heating system is by covering it with an insulating blanket. When you’re covering the storage tank, be sure you don’t enclose the temperature relief valve, the top part of the heater (if you’re using gas as fuel), and the heating element to avoid damaging it. You can always get help from a water heater technician or plumber to help you with insulating the heating unit.